シートヒーターの後付け

すべて バイク

通関手数料が発生するため、EU以外の国からのシートの発送をお受けすることができません。大変申し訳ありませんが、EU域外からシートを発送するお客様には、「シートヒーターの後付け」サービスをご提供することができません。

Retrofitting a 2-stage (15W/30W) seat heater for seats that do not have seat heating as standard.
Possible either only in the driver's position or in the driver's and passenger's position.

The original seat cover must be removed for installation, which is why it must not be glued to the foam core! Check whether the cover can be lifted off the foam core! To do this, pinch the cover between your thumb and forefinger and try to lift it (see figure 4). Attention: If the cover is glued, the seat heating can only be retrofitted in combination with a seat conversion (see seat conversion (one-piece seat) / seat conversion (two-piece seat))!

After installing a seat heater, the cable for the power supply is led out under the seat shell (approx. 20 cm long with plug connection). You will receive an approx. 120cm long connection cable with a two-stage, round built-in toggle switch (diameter approx. 20mm) for each heated seat position. The connection to the electrical system of your motorcycle should be carried out by a specialist workshop, knowledge of motorcycle electronics is required! A circuit diagram is included.

The seat heater will be installed on your seat - you have to send it in!
The change takes about 2-3 weeks.

The illustration of the lead-through of the connection cable is an example. The location of the grommet may vary depending on the seat and model.

商品についての質問

評価

評価：
この商品の平均の評価は、5の0です:
(後に 0 評価)

---

ここで新たな評価を行います

関連/推奨品

ワンピースシートの改良

BMW HP2 Enduro & HP2 Megamoto バイク

通関手数料が発生するため、EU...

価格 € 329,00
消費税別 及び 送料

詳細を表示

Examples for seat conversion

By default, we use non-slip black synthetic leather and black stitching...

詳細を表示

フロントシート、リアシートの改良

BMW R1200GS & R1200GS Adventure バイク

通関手数料が発生するため、EU...

価格 € 240,00
消費税別 及び 送料

詳細を表示